NEC Univerge SV8100 - Page 1283

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1259
15-07-01 Programmable Function Keys Assign a Voice Mail key to an
extension. You must enter the
Voice Mail key code (code 77)
followed by:
 Your own extension number if
you are setting up your own
Voice Mail key.
 A virtual extension number if
you are setting up a Message
Center key for a virtual
extension.
 A co-worker’s extension number
if you are setting up a Message
Center key for an installed
extension.
 An uninstalled extension
number if you are setting up a
Message Center key for an
uninstalled extension.
(Optional) Assign a Voice Mail
Record key to an extension (code
78).
(Optional) Assign a Personal
Answering Machine Emulation key
(code 16).
(Optional) Use a Call Redirect key
(49) to allow a user to transfer a call
to another extension or voice mail
without answering the call.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99 (Appearance
Function Code) (Service
Code 752 by default)
3
16-01-01 Department Group Basic Data
Setup – Department Name
Assign a name to the Extension
(Department) Groups.
Maximum 12 characters
(default not assigned)
3
16-01-02 Department Group Basic Data
Setup – Department Calling Cycle
Set the routing cycle for calls into a
department (i.e., when a user dials
the department pilot number). The
system can ring the highest priority
extension available (Priority
Routing, 0) or cycle in circular order
to a new idle extension for each
new call (Circular Routing, 1).
0 = Normal Routing
(Priority)
1 = Easy – UCD
Routing (Circular)
(default = 0)
3
16-01-03 Department Group Basic Data
Setup – Department Routing
When Busy (Auto Step Call)
Set how the system routes an
Intercom call to a busy Department
Group member. The caller can
hear busy tone (0) or overflow to
the first available Department
Group member (1). This option is
for Intercom calls to an extension,
not a pilot number.
0 = Normal (Intercom
caller to busy
department member
hears busy)
1 = Circular (Intercom
callers to busy
department member
routes to idle member)
(default = 0)
3
16-01-04 Department Group Basic Data
Setup – Hunting Mode
Set if an unanswered call should
hunt once stopping at the last
member tried (0) or continually hunt
through the idle members (1).
0 = Last extension is
called and hunting is
stopped
1 = Circular
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3