NEC Univerge SV8100 - Page 1316

Issue 1.0 UNIVERGE SV8100
2 - 1292 Voice Response System (VRS)
22-15-02 VRS Delayed Message for
Department Group – 1st Delayed
Message Number
For each Department Group, select
the message number to be played
as the first message (0~48). This
program is also used for VRS
Waiting Message.
0~101
0 = No Message
101 = Fixed Message
(default = 0)
3
22-15-03 VRS Delayed Message for
Department Group – 1st Delayed
Message Sending Count
For each Department Group, set
the number of times the first
message is played (0~255). This
program is also used for VRS
Waiting Message.
0~255 (time)
(default = 0)
3
22-15-04 VRS Delayed Message for
Department Group – 2nd Delayed
Message Number
For each Department Group, select
the message number to be played
as the second message (0~48).
This program is also used for VRS
Waiting Message.
0~101
0 = No Message
101= Fixed Message
(default = 0)
3
22-15-05 VRS Delayed Message for
Department Group – 2nd Delayed
Message Sending Count
For each Department Group, set
the number of times the second
message is played (0~255). This
program is also used for VRS
Waiting Message.
0~255 (time)
(default = 0)
3
22-15-06 VRS Delayed Message for
Department Group – Tone Kind at
Message Interval
For each Department Group,
determine what the caller hears
between messages (0 = Ringback
Tone, 1 = MOH, 2 = BGM). This
program is also used for VRS
Waiting Message.
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
(default = 0)
3
22-15-07 VRS Delayed Message for
Department Group – Disconnect
Time After the End of VRS
Waiting Message
For each Department Group, set
how long the system waits after
playing the VRS message before
disconnecting the call (0~64800
seconds). To prevent the call from
disconnecting, set this option to “0”.
This program is also used for VRS
Waiting Message.
0 = No Disconnect
1~64800 Seconds
(default = 60 seconds)
3
24-02-03 System Options for Transfer –
Delayed Call Forwarding Time
Set how long a telephone rings
before the call reroutes to the
programmed destination.
0~64800 (seconds)
(default = 10)
3
25-01-02 VRS/DISA Line Basic Data Setup
– DISA User ID
Select whether or not the DISA
User ID is to be used.
0 = Off
1 = On
(default = 0)
3
25-02-01 DID/DISA VRS Message For each Night Service mode, enter
1 at the “Talkie” prompt if trunk
should be automatically answered
by VRS and the message number
the caller should hear (1~48).
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3