NEC Univerge SV8100 - Page 1317

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1293
25-03-01 VRS/DISA Transfer Ring Group
With Incorrect Dialing
Set the destination that Automated
Attendant (OPA) calls ring if the
OPA caller dials an incorrect
extension number. This also sets
the options for DISA calls. The
system allows Ring Groups or
Disconnect = 0.
(Mode 1~8) All Trunks =
Ring Group 1
3
25-04-01 VRS/DISA Transfer Ring Group
With No Answer/Busy
Set the destination that Automated
Attendant (OPA) calls ring if the
OPA caller dials an extension that
does not answer or is busy. This
also sets the options for DISA calls.
The system allows Ring Groups or
Disconnect = 0.
Ring Groups:
1~100
Trunk Ports:
001~200
Day/Night Mode:
1~8
0 (Disconnect)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or VM8000
InMail)
(default = 0)
3
25-05-01 VRS/DISA Error Message
Assignment
For each trunk that is answered by
the VRS, enter the VRS message
(1~48) the outside caller hears if
they dial incorrectly after answer. If
you enter 0, the call reroutes
according to Program 25-03 and
Program 25-04. Make one entry for
each Night Service mode.
0~100 (0 = No Setting)
(default = 0)
3
25-06-01 VRS/DISA One-Digit Code
Attendant Setup – Next Attendant
Message Number
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls (see
Program 25-02-01), specify the
digit the Automated Attendant caller
dials (1~9, 0, ,
#). (Keep in mind
that if you assign destinations to
digits 3 and 4, outside callers
cannot dial system extensions.)
0~100 (0 = No Setting)
101 = Voice MAil
Answers
104 = Refer to 25-04:
VRS/DISA Transfer
Ring Group with No
Answer/ Busy
105 = Dial the other
extension
(default = 0)
3
25-06-02 VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls (see
Program 25-02-01), specify the
destination reached (four digits
maximum) when the caller dials the
single digit code.
Up to eight digits
(default not assigned)
3
25-07-02 System Timers for VRS/DISA –
VRS/DISA No Answer Time
If an Automated Attendant caller
dials an extension that does not
answer, the call waits this interval
before rerouting to the Ring Group
specified in PRG 25-03 and PRG
25-04. This setting also affects
unanswered DISA calls.
0~64800 (seconds)
(default = 0 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3