NEC Univerge SV8100 - Page 1335

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1311
VoIP ToS Setup:
The UNIVERGE SV8100 supports Quality of Service (QoS) Marking for the Session Initiation Protocol
(SIP).
IP Extension Numbering:
SIP Extension Codec Information:
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
84-10-01 ToS Setup – ToS Mode When Input Data is set to 1, Item No.
07 is invalid. When Data is set to 2,
Item No. 02 ~ 06 are invalid.
0 = Disable (Invalid)
1 = IP Precedence
2 = Diffserv
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-02-01 Extension Numbering Use this program to define the IP
Phone extension number.
 This designated extension is
used to register your IP Phone
and is programmed IP Phone
programming. Refer to the
Installation Instructions for
Installation Instructions for ITH-
4D/8D/16D-2/3 D
term
IPK
Terminals and the IP-R( ) (IPK)
Adapters.
Up to eight digits
1 101
2 102
3 103
~ ~
99 199
100 3101
~ ~
512 3513
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
84-19-01 SIP Extension CODEC
Information Basic Setup – G.711
Audio Frame Number
Use this program to define the G.71
audio Frame Size.
1~4
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
(default = 2)
3
84-19-02 SIP Extension CODEC
Information Basic Setup – G.711
Voice Activity Detection Mode
Use this program to Enable or
Disable Voice Activity Detection for
G.711.
0 = Disabled
1 = Enabled
(default = 0)
3
84-19-03 SIP Extension CODEC
Information Basic Setup – G.711
Type
Use this program to define the G.711
Type – Mu-law is recommended
when in USA.
0 = A-law
1 = u-law
(default = 0)
3
84-19-04 SIP Extension CODEC
Information Basic Setup – G.711
Jitter Buffer (min)
Use this program to define G.711
Jitter Buffer minimum accepted value
– values are set in ms.
0~160 ms
(default = 20 ms)
3