NEC Univerge SV8100 - Page 234

Issue 1.0 UNIVERGE SV8100
2 - 210 Caller ID
10-09-01 DTMF and Dial Tone Circuit
Setup
Allocate the circuits (1~16 or 1~64)
on the CD-CP00-AU for either
DTMF receiving or dial tone
detection.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
3
11-15-03 Service Code Setup,
Administrative (for Special
Access) – Backup Data Save
This service code is used for back
up the programmed data on the
SRAM and Call History to the
Flash ROM.
While saving the database, it may
cause system lock up.
MLT
#  # 9
3
14-01-20 Basic Trunk Data Setup – Block
Outgoing Caller ID
Enable (1) or Disable (0) the
system from automatically blocking
outgoing Caller ID information
when a user places a call.If
allowed (i.e. block, enabled), the
system automatically inserts the
Caller ID block code 1831 defined
in 14-01-21 before the user dialed
digits.
If prevented (i.e., block disabled),
the system outdials the call just as
it was dialed by the user.
Trunks 1~200
0 = Disable
1 = Enable
(default = 0)
3
14-01-21 Basic Trunk Data Setup – Caller
ID Block Code
Enter the code, up to eight digits,
that should be used as the Caller
ID Block Code. This code is
automatically inserted before
dialed digits if Program 14-01-20 is
set to ‘1’.
Trunks 1~200
Dial (up to eight digits)
1831
3
14-01-22 Basic Trunk Data Setup – Caller
ID to Voice Mail
Enable (1) or Disable (0) the
system ability to send the Caller ID
digits to voice mail.
Trunks 1~200
0 = Disable
1 = Enable
(default = 0)
3
14-02-10 Analog Trunk Data Setup – Caller
ID
Enable or Disable a trunk to
receive Caller ID information.
Trunks 1~200
0 = Disable
1 = Enable
(default = 1)
3
15-02-08 Multiline Telephone Basic Data
Setup – Automatic Handsfree
Use this option to set whether
pressing a key accesses a
One-Touch Key (1) or if it
preselects the key (0).
0 = Preselect
1 = One-Touch
(Automatic Handsfree)
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3