NEC Univerge SV8100 - Page 235

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 211
15-02-40 Multiline Telephone Basic Data
Setup – Additional Dial for Caller
ID Call Return
Enter the digits to be dialed in front
of the Caller ID when using Caller
ID Call Return.
Up to four digits
(0, 1~9,
#, )
(default not assigned)
3
15-03-09 Single Line Telephone Basic Data
Setup – Caller ID Function – For
External Module
Enable (1) or Disable (0) the Caller
ID FSK signal for an external Caller
ID module or a 3rd party vendor
telephone with Caller ID display.
If voice mail is used, this setting
must be disabled or the system
integration codes for disconnect
are incorrect. For Caller ID Sender
Queuing, set this option to “1”.
0 = Disable
1 = Enable
(default = 0)
3
15-03-10 Single Line Telephone Basic Data
Setup – Caller ID Name
Determine whether or not a single
line telephone extension user’s
telephone should display the Caller
ID name.
0 = Disable
1 = Enable
(default = 1)
3
15-03-11 Single Line Telephone Basic Data
Setup – Caller ID Type
Determine whether the Caller ID
type is FSK or DTMF.
0 = FSK
1 = DTMF
(default = 0)
15-07-01 Programmable Function Keys Use to assign functions to multiline
terminal line keys.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99 (Appearance
Function Code)
(Service Code 752 by
default)
3
20-02-08 System Options for Multiline
Telephones – LCD Display
Holding Time
This time determines how long a
user display shows Caller ID for a
second incoming call.
0~64800 (seconds)
(default = 5 seconds)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-08-15 Class of Service Options
(Outgoing Call Service) – Block
Outgoing Caller ID
Turns Off (0) or On (1) a user Class
of Service from automatically
blocking outgoing Caller ID
information when a call is placed. If
block is enabled, the system
automatically inserts the Caller ID
block code 1831 defined in
Program 14-01-21 before the user
dialed digits (this requires Program
14-02-10 to be enabled). If block is
disabled, the system outdials the
call just as it was dialed by the
user.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3