NEC Univerge SV8100 - Page 236

Issue 1.0 UNIVERGE SV8100
2 - 212 Caller ID
20-09-02 Class of Service Options
(Incoming Call Service) – Caller
ID Display
Turns Off (0) or On (1) the Caller
ID display at an extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-09-04 Class of Service Options
(Incoming Call Service) –
Notification for Incoming Call
List Existence
Determine whether or not the
CHECK LIST message is
displayed to indicate a missed call.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
Manually (0) or Automatically (1)
receive off-hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-19-01 System Options for Caller ID –
Caller ID Displaying Format (If
displaying digits are more than
12 digits)
Determine whether the first 10
digits (0) or last 10 digits (1) should
be displayed when Caller ID
exceeds 12 digits.
0 = First 10 digits
(Upper)
1 = Last 10 digits
(Lower)
(default = 0)
3
20-19-05 System ID Options for Caller ID –
Caller ID Sender Queuing Time
(Sender Wait)
With the Caller ID Sender Queuing
option, determine how long an
incoming call will wait in queue for
a DSP resource to become
available. If a resource becomes
available during this time, the call
immediately rings the single line
telephone with Caller ID. If the time
expires before a resource
becomes available, the system
rings the single line telephone
without Caller ID (until the queuing
time expires, the single line
telephone does not ring). If the
queuing timer is set to "0", the
system does not queue the
incoming call.
0~64800 (seconds)
(default = 0 seconds)
3
20-20-01 Message Setup for Non-Caller ID
Data – Private Call
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as a private
call.
24 Alphanumeric
Characters
(default = PRIVATE)
3
20-20-02 Message Setup for Non-Caller ID
Data – Call from Out of Service
Area
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as an out-of-
service area call.
24 Alphanumeric
Characters
(default = OUT OF
AREA)
3
20-20-03 Message Setup for Non-Caller ID
Data – Call Information with Error
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as a call
with a CID error.
24 Alphanumeric
Characters
(default = NO CALLER
INFO)
3
90-03-01 Save Data Use to save the programmed data
on the SRAM and Flash ROM to
the 16MB/32MB ATA removable
Compact Flash memory card.
Also, used to save stored Caller ID
if permanently saved with service
code #*#9 (11-15-03).
Dial 1 + press Hold
(Press Hold to cancel.)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3