NEC Univerge SV8100 - Page 250

Issue 1.0 UNIVERGE SV8100
2 - 226 Central Office Calls, Answering
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Digits 0~9
(default = 4)
3
22-01-01 System Options for Incoming
Calls – Incoming Call Priority
Use this option to determine if
Intercom calls or trunk calls have
answer priority when both are
ringing simultaneously.
0 = Intercom call
priority
1 = Trunk call priority
(default = 1)
3
22-01-02 System Options for Incoming
Calls – Incoming Call Ring No
Answer Alarm
Enable (1) or Disable (0) the
Incoming Call RNA Alarm. If
enabled, the ring cadence will
change for a call that rings longer
than the interval set in Program
22-01-03.
0 = Disable
1 = Enable
(default = 0)
3
22-01-03 System Options for Incoming
Calls – Ring No Answer Alarm
Time
Set the Ring No Answer Alarm
interval. If a trunk rings a multiline
terminal longer than this interval,
the system changes the ring
cadence.
0~64800 (seconds)
(default = 60 seconds)
3
22-01-04 System Options for Incoming
Calls – DIL No Answer Recall
Time
A DIL that rings its programmed
destination longer than this interval
diverts to the DIL No Answer Ring
Group (set in Program 22-08).
0~64800 (seconds)
(default = 0 seconds)
3
22-02-01 Incoming Call Trunk Setup Use this option to set the feature
type for the trunk you are
programming.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-03-01 Trunk Ring Tone Range – Ring
Tone Pattern
Assign Ring Tone Ranges to trunks.
Trunks ring extensions according to
the Ring Tone Range selected in
Program 22-03-0 and the settings
made with either Service Code 720
or Program 15-02-02.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3