NEC Univerge SV8100 - Page 296

Issue 1.0 UNIVERGE SV8100
2 - 272 Code Restriction
21-05-12 Toll Restriction Class – PBX Call
Restriction
For the Toll Restriction Class you
select, Enable (1) or Disable (0)
PBX Call Restriction.
1~4 =Table
0 = Disable (None)
Default:
1~6, 8~15 = 0
7 = 1
3
21-05-13 Toll Restriction Class –
Restriction of Tie Line Calls
Select whether or not the Toll
Restriction set up in Program
34-08-01 is Enabled (1) or Disabled
(0).
0 = Disable
1 = Enable
(default = 0)
3
21-06-01 Toll Restriction Table Data Setup
– International Call Restriction
Table
Enter the international dialing codes
you want to restrict.
Dial (Up to four digits)
default:
Tables 1
~10 = No
Setting
3
21-06-02 Toll Restriction Table Data Setup
– International Call Permit Code
Table
Enter the international dialing codes
you want to permit.
Dial (Up to six digits)
Default:
Tables 1~20 = No
Setting
3
21-06-03 Toll Restriction Table Data Setup
– Maximum Number of Digits
Table Assignment
Select the maximum number of
digits allowed in outgoing calls for
each table (4~30).
4-30
default:
Tables 1~ 4 = 30
3
21-06-04 Toll Restriction Table Data Setup
– Common Permit Code Table
Program codes into the Common
Permit Code Table.
Dial (Up to four digits)
default:
Table 1 = 000
Table 2~10 = Not
Assigned
3
21-06-05 Toll Restriction Table Data Setup
– Common Restriction Table
Program codes into the Common
Restrict Code Table.
Dial (Up to 12 digits)
default:
All Tables = Not
Assigned
3
21-06-06 Toll Restriction Table Data Setup
– Permit Code Table
Program codes into the Permit
Code Tables.
Dial (Up to 12 digits)
default:
Table 1~4 = No Setting
3
21-06-07 Toll Restriction Table Data Setup
– Deny Restriction Table
Program codes into the Restrict
Code Tables (200 codes per table
maximum).
Dial (Up to 12 digits)
default:
Table 1~4 = No Setting
3
21-06-08 Toll Restriction Table Data Setup
– PBX Access Code
The system allows up to four tables
for PBX access codes. PBX
Access Codes can have up to two
digits, using 0~9,
#,  and LINE
KEY 1 (don’t care). Refer to the
PBX Compatibility feature for the
specifics.
Dial (Up to two digits)
default:
Table 1~4 = No Setting
3
21-21-01 Toll Restriction for Trunks
(Seized Trunk Basis Setting) –
Restriction Class
Enter the Toll Restriction Class for
the selected trunk.
1~15
(default = 1)
3
34-01-05 E&M Tie Line Basic Setup –
System Toll Restriction
Determine if an incoming Tie Line
call should be subject to Toll
Restriction.
0 = No (Off)
1 = Yes (On)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3