NEC Univerge SV8100 - Page 375

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 351
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turns Off or On an extension ability
to have calls queued if a call rings
the extension when it is busy.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-17 Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
Turns Off or On an extension user
ability in a Department Group to use
the Trunk-to-Trunk Forwarding
service codes.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
Manually (0) or Automatically (1)
receive Off-Hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-14 Class of Service Options
(Supplementary Service) –
Department Calling (PLT No
Called Extension)
Turns Off or On an extension user
ability to call a Department Group
Pilot.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
22-02-01 Incoming Call Trunk Setup –
Incoming Type
If you want a trunk to be a DIL to a
Department Group, assign Service
Type 4 for each Night Service
Mode. Refer to Program 22-07-01.
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-07-01 DIL Assignment For each trunk assigned Service
Type 4 in Program 22-02-01 above,
assign the DIL destination as the
Department Group pilot number (as
assigned in Program 11-07-01).
Extension Number
(maximum eight digits)
(default not assigned)
3
24-02-05 System Options for Transfer –
Message Wait Ring Interval Time
For Single Line Telephones (SLTs)
without message waiting lamps, this
is the time between intermittent
ringing. If this value is set to 0, the
system rings once.
0~64800 (seconds)
(default = 30 seconds)
3
24-02-08 System Options for Transfer –
Delayed Transfer Timer for All
Department Groups
Determine the time a call should
ring a Department Group before
transferring the call.
0~64800 (seconds)
(default = 10 seconds)
3
24-05-01 Department Group Transfer Target
Setup
Assign the Speed Dial bin to each
Department Group to hold the
destination for the immediate
automatic transfer of ICM and
transferred calls to the Department
Group feature.
0~1999
(default = 1999)
3
40-01-10 Department Group Call when the
Automated Attendant is activated
Used to Enable or Disable
Department Group Call when the
Automated Attendant is activated.
0 = Disabled (Off)
1 = Enabled (On)
(Default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3