NEC Univerge SV8100 - Page 414

Issue 1.0 UNIVERGE SV8100
2 - 390 Direct Inward Line (DIL)
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Select whether an extension should
display the reason a call is being
transferred to their extension (Call
Forward Busy, Call Forward No
Answer, DND).
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
22-01-04 System Options for Incoming
Calls – DIL No Answer Recall
Time
A DIL that rings its programmed
destination longer than this time
diverts to the DIL No Answer Ring
Group (set in Program 22-08).
0~64800 (seconds)
(default = 0 seconds)
3
22-02-01 Incoming Call Trunk Setup Assign each DIL Service Type 4.
Make an entry for each Night Service
mode.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-04-01 Incoming Extension Ring Group
Assignment
Assign the extensions that should
receive the overflow to the ring group
programmed in Program 22-08. Set
the ringing in Program 22-06.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
3
22-07-01 DIL Assignment Set the destination extension
number for each DIL – for each Night
Service mode. The destination can
be an extension port, virtual
extension number, or Department
Group pilot number (as assigned in
Program 11-07-01).
Extension Number
(maximum eight digits)
(default not assigned)
3
22-08-01 DIL/IRG No Answer Destination For each DIL with delayed ringing,
enter the DIL No Answer Ring
Group. An unanswered DIL rings this
group after the DIL No Answer Time.
Make an entry for each Night Service
mode.
0 (No Setting)
001~100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or VM8000 InMail)
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3