Chapter 5 System Data Mode
5-6 NWA-033628-001 Rev.1.0
Using System Data Mode
Searching for System Data Pertaining to Function Settings
You can search for a function name and set system data. Do as instructed below.
STEP1: Enter part of the function name in the Search Character Entry field in a submenu display.
• Character length :Up to 256 characters
• Alphabetical character :Upper case and lower case are searched as same characters.
STEP2: Click the [Start] button.
A list of search results is displayed in the View Search Results field.
STEP3: Click an item to be set in the View Search Results field.
A screen for configuring the selected command is displayed.
System data pertaining to a function setting has now been located.
For the subsequence course of operation, refer to Steps 2 and 3, “Configuring System Data”.
Page 5-3
Search Caracter Entry field
[Start] button
View Search Results field
To Next Page
Loading...
