SECTION 2
INSTALLING THE PRINTER
5
Section 2 – Installing the Printer
Before using the Printer the following must be done:
• T
ransport Inspection. Upon delivery; inspect packaging and report any issues to the Carrier
• Gather Tools.
• Choose a location for the Printer
• Unpack and verify Accessory Box contents
• Attach the Media Guides to the Printer
• Remove the Service Station Transport Tab and Shipping Tape
• Plug in the Printer and Connect it to the Computer
• Install the Printer Software (Driver & Toolbox)
• Install the Ink Tanks
• Install the Printhead
• Install the PPS spacers (if needed)
Transport Inspection
The printer is shipped in appropriate packaging so that, under normal shipping conditions, it reaches its
destination without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport.
Transport and storage should take place under the following conditions:
- At temperatures between -25°C and +50°C (-13 °F to 122 °F).
- At a relative air humidity between 5% and 95%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
I
MPORTANT Please save the packaging materials for future use! It will be required if you ever need to
ship the printer. Before shipping; please refer to the section titled “Preparing the Printer for Transport”.
Tools Needed
• Knife and scissors to open packaging
• Carpenters Level (recommend using 18” or longer level)
• Protective, nitrile powder-free gloves should be worn to avoid getting ink on hands when
removing protective packaging materials from the ink coupling areas, the Ink Tank areas, and
when installing/removing Printhead Cartridge and Ink Tanks.
• Distilled or de-ionized water
• Non-abrasive, lint free cloths
To Next Page
Loading...
Need help?
General
