SECTION 2
INSTALLING THE PRINTER
12
Connecting the Printer
Plugging in the Printer
• Check to make sure the Main Power Switch [1] is in the OFF position.
• Plug the Power Cord into the receptacle [1] at the rear of the Printer.
• Connect the other end of the Power Cord to a compatible AC Outlet
that supplies 100-240 volts AC, 50/60 Hz and provides earth ground.
DO NOT USE AN ADAPTER PLUG OR EXTENSION CORD TO
CONNECT THE PRINTER TO THE WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE AN OUTLET THAT SHARES THE SAME CIRCUIT
WITH LARGE ELECTRICAL MACHINES OR APPLIANCES
.
Powering the Printer ON and OFF
Powering-Up the Printer:
1. Turn ON the Main Power Switch [1].
2. Press the Control Panel’s ON/OFF Button
.
Wa
it about 45 seconds for the print engine to power-up (ON/OFF button will illuminate).
Powering-Down the Printer:
1. Press the Control Panel’s ON/OFF Button
.
W
ait for the print engine to power-down (all Control Panel Buttons will turn OFF).
2. Turn OFF the Main Power Switch [1].
BEFORE POWERING OFF THE MAIN POWER SWITCH, ALWAYS POWER
DOWN THE PRINT ENGINE, USING THE ON/OFF BUTTON.
IF THIS RULE IS NOT FOLLOWED DAMAGE TO THE PRINTHEAD AND OR INK
SYSTEM CAN RESULT.
FOR BEST SYSTEM PERFORMANCE; IT IS RECOMMENDED TO KEEP THE
PRINT ENGINE POWERED-UP (ON/OFF LIGHT ILLUMINATED) AT ALL TIMES.
To Next Page
Loading...
Need help?
General
