User Manual
Page 55
5.3 39BUncompleted Irrigation
The Uncompleted Irrigation table provides information of irrigations that were started but could not be completed due
to a failure. To understand why irrigation was not completed, it is advisable to cross-reference between this table and
the Alarm Definition in section 4.3. The Uncompleted Irrigation table consists of up to 200 lines. Note that if the letter
'C' appears, it refers to a program that was triggered by condition program.
Each line includes information regarding when the irrigation was stopped and added to the uncompleted irrigations
table.
Item Description
Date in which the current line was added to the uncompleted irrigation table.
Time in which the current line was added to the uncompleted irrigation table
Prog. No.
92- The program that was added to the table was started manually.
93- The relevant irrigation was added to the uncompleted irrigations table for the second time (or
more) consecutively.
Vl. No.
Indicates the associated valve. If a group of valves that is configured to irrigate together is stopped,
only the first valve is written but a ‘+’ sign is added next to it to indicate that more valves are
associated.
The NMC-Pro will attempt to complete the irrigations from the current day (until end day time) upon
manual or automatic alarm reset.
The valve column of irrigations that are to be completed will be highlighted.
The valve column of irrigations that are currently being completed will blink.
Indicates the associated run time program.
Indicates the associated dosing program.
Planned quantity according to the run time program.
In order to manually stop an uncompleted irrigation you must go to the START/STOP VALVE in section 3.3 because
the activation is according to single valves.
UNCOMPLETED IRRIGATION
hh:mm
No.
No.
Prog
2
20-Dec-06
09:25
2
1
1
--
To Next Page
Loading...
Need help?
General
