User Manual
Page 9
2 1BPROGRAM MENU
The Program Menu is used to configure the irrigation programs. Configuration is a multistep process consisting of
setting the following:
• Run Time Program (length of irrigation time or quantity of water to be distributed), page 9
• Dosing Program (fertilizer distribution program), page 11
• Irrigation (time frame and other parameters), page 17
In addition (or as alternative) to starting the irrigation based on time, irrigation can be set to begin based on:
• Irrigation Based on External Conditions, page 22
• Irrigation Based on Radiation Sum, page 27
• Irrigation Based on VPD Sum, page 28
Furthermore, you can adjust the irrigation process based on environmental factors such as the amount of radiation,
the temperature, or other factors. Refer to Introduction to the Influence Program and Introduction to the Influence
Program, page 29 for more details.
Lastly, use this menu to configure the following functions:
• Agitator, page 37
• Selector, page 38
• Filter Flushing, page 38
• Cooling, page 41
• Misting, page 42
• Water Heating, page 42
2.1 10BRun Time Program
For every irrigation program, define a Run Time program, which defines the how much water to distribute. Run Time
can be based on either length of time or quantity of water. You can define up to 60 Run Time programs.
As an option, you can configure irrigation to run for a certain amount of time or quantity before dosing begins and/or
after dosing ends. This process rinses the irrigation pipes of any residual matter.
To set the irrigation Run Time:
1. Go to Program > Water Run Time.
2. Select QTY or TIME.
3. Enter the water quantity/total run time.
4. Enter the Before and/or After quantity/time (optional).
5. Repeat as required for each program.
To Next Page
Loading...
Need help?
General
