Netafim nmc-pro - Changing Operation Mode

NMC-PRO
User Manual
Page 8
GENERAL INFORMATION
To change the operation mode, press the LOG IN key
Click the MODE icon and insert the password
The controller recognizes the operation mode according to the password that is entered:
MODE
PASSWORD
Read Only 0000
User 9785 or 0101
If an incorrect password is entered, this screen appears.
The Operation mode can be configured to automatically return to the “Read-Only” mode after a certain amount of
time.

Note: Refer to the SYSTEM SETUP section in the Installation Manual.
SYSTEM SETUP
HISTORY
History Resolution ► 1 HOUR
WEATHER STATION
Controller Function ► LOCAL
OPERATION MODE
Automatic return to RO mode ► NO
Return period to RO mode ► 00:10
COMMUNICATION
Controller Number ► 1
Lower Port – Protocol ► NMC NET
Lower Port – BaudRate ► 9600
Upper Port – Protocol ► NONE
Upper Port – BaudRate ► 9600
• To perform a cold start or firmware upgrade, the controller must be in the “Technician” mode.
• If there is a power failure, the controller powers up with the last used mode.
OPERATION MODE
Please Enter Password
OPERATION MODE – USER
?
1
2
3
OPERATION MODE
WRONG PASSWORD
Please Try Again.