Page 99 of 121
Advanced> SNMP> Host Table
The SNMP Host Table screen allows you to add and remove hosts from access rights that have been granted to community groups. The
permissions GET, SET and TRAP are assigned to a community name and then these permissions are assigned to individual machines by adding
those machines and their IP address to the appropriate community string. Host Authorization can be Enabled or Disabled.
If Host Authorization is enabled, the host must be added to this table, through the Console port connection in order for an end station to be access
the switch via SNMP.
Figure 7-30: SNMP Management > Host Table
To Next Page
Loading...
