Page 64 of 121
Main Menu> Advanced Menu> SNMP> Host Table
The screen, shown in Figure 6-29, grants a host the access rights to the switch.
Host Authorization must be enabled to use the host table. Host Authorization is used as a security feature to limit people who are not listed in the
host table from accessing the switch.
If Host Authorization is enabled, the host must be added to this table, through the Console port connection in order for an end station to be access
the switch via SNMP.
Add host
o
Enter the host name, IP address, and the community string. Press Enter after each entry to move to the next field.
o
In the Status field, press the Spacebar until the desired Status is displayed.
o
Press Ctrl-W to save all changes.
Figure 6-29: SNMP Management: Host Table
To Next Page
Loading...
Need help?
General