NETGEAR WNDAP360 User Manual

Management
77
ProSafe Dual Band Wireless-N Access Point WNDAP360
Enable Rogue AP Detection and Monitor Access Points
Enable and Configure Rogue AP Detection
The wireless access point can detect rogue access points and prevent them from connecting
to the wireless access point. The wireless access point maintains a list of access points it
detects in the area. Initially all detected access points are displayed in the Unknown AP List.
You restrict communication to approved access points by adding them to the Known AP List
and enabling the rogue AP detection feature.
If you enable rogue AP detection, the wireless access point continuously scans the wireless
n
etwork and collects information about all access point on its channel.
 To enable and configure rogue AP detection:
1. Select Con
figuration > Security > Advanced > Rogue AP. The Rogue AP screen
displays. (The following figure shows examples in the Known AP List and Unknown AP
List.)
Wireless 802.11b, Wireless 802.11bg, or Wireless 801.11ng
The section heading depends on the configured wireless mode.
Unicast Packets The number of unicast packets received an
d transmitted over the wireless
connection since the wireless access point was restarted.
Broadcast Packets The number of broadcast packets received and transmitted over the
wirele
ss connection since the wireless access point was restarted.
Multicast Packets The number of multicast packets received and transmitted over the wireless
connection since the wireless access point was restarted.
Total Packets The total number of packets received and transmitted over the wireless
conne
ction since the wireless access point was restarted.
Total Bytes The total number of bytes received and transmitted over the wireless
conne
ction since the wireless access point was restarted.
Wireless 802.11a or Wireless 801.11na
The section heading depends on the configured wireless mode.
The fields that are displayed are the same as the on
es for the 2.4 GHz modes (see the previous rows).
Client Association
802.11b Radio,
802.11bg Radio, or
802.11ng Radio
The number of associated clients connected to the
radio in the configured
wireless modes.
802.11na Radio or
802.11a Radio
Table 20. Statistics Fields (Continued)
Field Description

NETGEAR WNDAP360 Specifications

General

VLAN support	Yes
Frequency band	2.4 - 5 GHz
Number of users	50 user(s)
Cabling technology	10/100/1000BASE-T(X)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1000 Mbit/s
Antenna connector type	SMA
Antenna gain level (max)	5 dBi
Weight (imperial)	1.93 lbs
Networking features	Gigabit Ethernet
Compliance industry standards	IEEE 802.11a, IEEE 802.11g, IEEE 802.11n, IEEE 802.3af, IEEE802.1x
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, EAP, EAP-TLS, EAP-TTLS, PEAP, SSH, SSL/TLS, TTLS, WEP, WPA, WPA2
Power requirements	12 VDC, 1A
Power consumption (typical)	10.51 W
Minimum system requirements	Internet Explorer 6.0, Mozilla Firefox 1.5
Compatible operating systems	- Windows Vista, XP, 2000, 98, Me - Mac OS - UNIX - Linux
Internal	No
LED indicators	LAN
Cable lock slot type	Kensington

Weight and Dimensions

Height	54.76 mm
Weight	878 g
Dimensions (WxDxH)	253.75 x 253.76 x 54.76 mm