NETGEAR WNDAP360 User Manual

Troubleshooting
104
ProSafe Dual Band Wireless-N Access Point WNDAP360
Basic Functioning
After you turn on power to the wireless access point, check that the following sequence
of events occurs:
• Th
e Power/Test LED is first steady amber, then goes off, and then blinks green before
turning steady green after about 45 seconds.
• Th
e Active LED is lit or blinks green when there is Ethernet traffic.
• Th
e LAN LED indicates the LAN speed: green for 1000 Mbps, amber for 100 Mbps, and
no light for 10 Mbps.
• Th
e WLAN LED is lit or blinks green when the wireless LAN (WLAN) is ready.
If any of these conditions does not occur, see to the appropriate following section.
No LEDs Are Lit on the Wireless Access Point
It takes a few seconds for the power LED to light up. Wait a minute and check the Power LED
status on the wireless access point. If the wireless access point has no power:
If you use a PoE switch to provide power to the wireless access point, check these
items
:
• Make sure
that the Ethernet cable between the wireless access point and the PoE switch
is correctly connected at both ends.
• Ma
ke sure that the power cord of the PoE switch is plugged into a working power outlet or
power strip.
• Make
sure that your PoE switch is functioning normally.
If you use a power cord to provide power to the wireless access point, check these
items
:
• Make
sure that the power cord is connected to the wireless access point.
• Make
sure that the power adapter is connected to a functioning power outlet. If it is in a
power strip, make sure that the power strip is turned on. If it is plugged directly into the
wall, verify that it is not a switched outlet.
• Make
sure that you are using the correct NETGEAR power adapter that is supplied with
your wireless access point.

NETGEAR WNDAP360 Specifications

General

VLAN support	Yes
Frequency band	2.4 - 5 GHz
Number of users	50 user(s)
Cabling technology	10/100/1000BASE-T(X)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1000 Mbit/s
Antenna connector type	SMA
Antenna gain level (max)	5 dBi
Weight (imperial)	1.93 lbs
Networking features	Gigabit Ethernet
Compliance industry standards	IEEE 802.11a, IEEE 802.11g, IEEE 802.11n, IEEE 802.3af, IEEE802.1x
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, EAP, EAP-TLS, EAP-TTLS, PEAP, SSH, SSL/TLS, TTLS, WEP, WPA, WPA2
Power requirements	12 VDC, 1A
Power consumption (typical)	10.51 W
Minimum system requirements	Internet Explorer 6.0, Mozilla Firefox 1.5
Compatible operating systems	- Windows Vista, XP, 2000, 98, Me - Mac OS - UNIX - Linux
Internal	No
LED indicators	LAN
Cable lock slot type	Kensington

Weight and Dimensions

Height	54.76 mm
Weight	878 g
Dimensions (WxDxH)	253.75 x 253.76 x 54.76 mm