NETGEAR WNDAP360 User Manual

58
4
4. Management
This chapter describes how to use the management and monitoring features of your ProSafe
Dual Band Wireless-N Access Point WNDAP360. This chapter includes the following sections:
• Enable Remote Management
• Upgrade the Wireless Access Point Software
• Manage the Configuration File or Reset to Factory Defaults
• Change the Administrator Password
• Enable the Syslog Server
• Monitor the Wireless Access Point
• Enable Rogue AP Detection and Monitor Access Points
Enable Remote Management
Both Simple Network Management Protocol (SNMP) and the remote console Secure Shell
(SSH) are enabled by default, which allows for remote management of the wireless access
point from a client running SNMP management software, as well as from a SSH client. The
Telnet console is disabled by default.

NETGEAR WNDAP360 Specifications

General

VLAN support	Yes
Frequency band	2.4 - 5 GHz
Number of users	50 user(s)
Cabling technology	10/100/1000BASE-T(X)
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1000 Mbit/s
Antenna connector type	SMA
Antenna gain level (max)	5 dBi
Weight (imperial)	1.93 lbs
Networking features	Gigabit Ethernet
Compliance industry standards	IEEE 802.11a, IEEE 802.11g, IEEE 802.11n, IEEE 802.3af, IEEE802.1x
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	64-bit WEP, 128-bit WEP, EAP, EAP-TLS, EAP-TTLS, PEAP, SSH, SSL/TLS, TTLS, WEP, WPA, WPA2
Power requirements	12 VDC, 1A
Power consumption (typical)	10.51 W
Minimum system requirements	Internet Explorer 6.0, Mozilla Firefox 1.5
Compatible operating systems	- Windows Vista, XP, 2000, 98, Me - Mac OS - UNIX - Linux
Internal	No
LED indicators	LAN
Cable lock slot type	Kensington

Weight and Dimensions

Height	54.76 mm
Weight	878 g
Dimensions (WxDxH)	253.75 x 253.76 x 54.76 mm