Introduction
12
ProSafe Dual Band Wireless-N Access Point WNDAP360
Rear Panel
Figure 2.
Table 1. Top Panel LEDs
Item LED Description
1 Power/Test Off Power is off.
On (green) Power is on.
Amber, then blinking
gree
n
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
L
ED remains amber or continues to blink green, it
indicates a system fault.
2 Active Off No Ethernet traffic is detected or no link is detected.
On or blinking (green) Ethernet traffic is detected.
3 LAN Off 10 Mbps or no link is detected.
Amber 10/100 Mbps link is detected.
Green 1000 Mbps link is detected.
4
2.4 GHz WLAN Off Wireless 802.11b/g/n (2.4 GHz) LAN is not ready or
no wireless activity is detected.
On or blinking (green) Wireless 802.11b/g/n (2.4 GHz) LAN is ready or
wireless activity is detected.
5
5 GHz WLAN Off Wireless 802.11n/a (5 GHz) LAN is not ready or no
wireless activity is detected.
On or blinking (green) Wireless 802.11n/a (5 GHz) LAN is ready or wireless
ac
tivity is detected.