Why Newtec TP210 Modem shows 'ACM terminal can not login onto CCM hub'?
If the Newtec Modem web interface displays 'ACM terminal can not login onto CCM hub', it indicates that the terminal software is not compatible with the satellite network. Contact your ISP.
Why Newtec TP210 shows 'CCM terminal can not login onto ACM hub'?
If the Newtec Modem web interface displays 'CCM terminal can not login onto ACM hub,' it means that the terminal software is not compatible with the satellite network. Contact your ISP.
Describes symbols used in the manual and their meanings.
Lists document versions, release dates, and software applicability.
Lists the available satellite terminal models and their antenna sizes.
Lists critical warnings for safety, potential hazards, and warranty implications.
Provides a description of the satellite terminal and its capabilities.
Outlines the necessary installation tasks and refers to the setup manual.
Details the IPmodem component, including its front and back panels.
Describes the functionality and parts of the antenna pointing device.
Details the types of cables included with the satellite terminal system.
Describes the iLNB (Interactive Low Noise Block-down converter) component.
Provides information about the satellite antenna and its assembly.
Steps to configure your computer's network settings for the terminal.
Instructions on accessing the terminal's web interface.
General overview of the web interface layout and structure.
Procedure for rebooting the IPmodem via the web interface.
Explanation of the status LEDs on the IPmodem and their meanings.
Details on the different sections of the terminal's status page.
Introduction to the configuration settings for the terminal.
Information related to the device's software and hardware.
Information and status regarding the antenna pointing procedure.
Overview of the diagnostic tests that can be performed on the terminal.
Guide for connecting a single computer to the IPmodem.
Instructions for connecting a local area network (LAN) to the IPmodem.
Procedure to set or change IP settings on Windows 7.
Procedure to set or change IP settings on Windows Vista.
Procedure to set or change IP settings on Windows XP.
Procedure to set or change IP settings on Mac OS X.
Technical specifications for the IPmodem indoor unit.
Electrical and environmental specifications for the coaxial cable.
Performance and environmental specifications for the iLNB outdoor unit.
Environmental and dimensional specifications for the satellite antenna.
To Next Page
General
