EasyManuals Logo

Nexo NXAMP 4X4 Service Manual

Nexo NXAMP 4X4
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
q) Fasten the wires (WK17090 and WK17110) with a cord
holder at the hole of the OPT-AN board. Then connect
the flat cable (WK02120). (Fig. 30)
r) Fasten the wires (WK02080, WK17090, WK17100,
WK17110 and WK02070) with a cord holder at the close
area to the OPT-AN circuit board. (Fig. 30)
s) Fasten the wires (WK68740, WK68760 and WK68770)
with a cord holder. (Fig. 30)
t) Bend the flat cable as shown in the figure. (Fig. 30)
u) Bend the flat cable to prevent it from touching the top
cover. (Fig. 31, 32)
q) 材(WK17090、WK17110)
OPT-AN シートの穴へ固定します。その後、フラッ
トケーブル(WK02120)を接続します。(図 30)
r) OPT-AN シートの横で線材WK02080、WK17090、
WK17100、WK17110、WK02070)をインシュロック
タイで固定します。(図 30)
s) 線材(WK68740、WK68760、WK68770)を図のよう
にインシュロックタイで固定します。(図 30)
t) フラットケーブルを図のように折り曲げます。(図 30)
u) トップカバーとの接触を避けるためにフラットケーブ
ルを折り曲げます。(図 31、32)
Fig. 30
(図 30)
Fig. 31
(図 31)
Fig. 32
(図 32)
t)
u)
s)
r)
q)
q)
q)
NXAMP4x4
20

Table of Contents

Other manuals for Nexo NXAMP 4X4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nexo NXAMP 4X4 and is the answer not in the manual?

Nexo NXAMP 4X4 Specifications

General IconGeneral
BrandNexo
ModelNXAMP 4X4
CategoryRecording Equipment
LanguageEnglish