Nokia 7210 - Page 103

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
File System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
103
When an attrib command is entered to list a specific file or all files in a directory, the file’s
attributes are displayed with or without an “R” preceding the filename. The “R” implies that
the +r is set and that the file is read-only. Files without the “R” designation implies that the -r
is set and that the file is read-write-all.
Parameters file-url — Specifies the URL for the local file.
+r Sets the read-only attribute on the specified file.
-r Clears/resets the read-only attribute on the specified file.
Values
+r — Keyword to set the read-only attribute on the specified file.
-r — Keyword to reset the read-only attribute on the specified file.
cd
Syntax cd [file-url]
Context file
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command displays or changes the current working directory in the local file system.
file-url — local-url | remote-url
local-url — [cflash-id/ | usb-flash-id] [file-path]
remote-url — [{ftp:// | tftp://} login:pswd@remote-locn/] [file- path]
remote-locn — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — a string up to 32, for link local addresses
cflash-id or usb-flash-id — uf1: (7210 SAS-M)
cf1:, cf2:, uf1: (7210 SAS-T, 7210 SAS-Sx/S 1/10GE:
standalone and standalone-VC, 7210 SAS-Sx 10/
100GE, and 7210 SAS-Mxp)
cf2:, cf2-A:, cf2-B:, uf1:, uf1-A:, uf1-B: (7210 SAS-R6
and 7210 SAS-R12)
cf1:, cf2: (7210 SAS-Sx/S 1/10GE: standalone and
standalone-VC)