Nokia 7210 - Page 335

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
335
Action
Use this command to configure the parameters for a script, including the maximum
amount of time to keep the results from a script run, the maximum amount of time a
script may run, the maximum number of script runs to store and the location to store
the results.
Use the following CLI syntax to configure the parameters for a script.
CLI Syntax: config>system>cron
action action-name [owner action-owner]
expire-time {seconds|forever}
lifetime {seconds|forever}
max-completed unsigned
results file-url
script script-name [owner script-owner]
shutdown
The following example shows the command usage to configure the parameters for a
script.
Example: config>system>cron# action test
config>system>cron>action# results ftp://
172.22.184.249/./sim1/test-results
config>system>cron>action# no shut
The following sample output shows a script named “test” receiving an action to store
its results in a file called “test-results”.
A:sim1>config>system>cron# info
----------------------------------------------
script "test"
location "ftp://172.22.184.249/./sim1/test.cfg"
no shutdown
exit
action "test"
results "ftp://172.22.184.249/./sim1/test-results"
no shutdown
exit
----------------------------------------------
A:sim1>config>cron# script
Schedule
The schedule function configures the type of schedule to run, including one-time only
(oneshot), periodic or calendar-based runs. All runs are determined by month, day of
month or weekday, hour, minute and interval (seconds). If end-time and interval are
both configured, whichever condition is reached first is applied.