Nokia 7210 - Page 397

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
397
No CLLI validity checks other than truncating or padding the string to eleven characters are
performed.
Only one CLLI code can be configured, if multiple CLLI codes are configured the last one
entered overwrites the previous entry.
The no form of this command removes the CLLI code.
Parameters clli-code — Specifies the 11 character string CLLI code. Any printable, seven bit ASCII
characters can be used within the string. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes. If
more than 11 characters are entered, the string is truncated. If less than 11
characters are entered the string is padded with spaces.
config-backup
Syntax config-backup count
no config-backup
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the maximum number of backup versions maintained for
configuration files and BOF.
For example, assume count is set to 5, and the configuration file is called xyz.cfg. When a
save command is executed, the file xyz.cfg is saved with a .1 extension. Each subsequent
config-backup command increments the numeric extension until the maximum count is
reached.
xyz.cfg
xyz.cfg.1
xyz.cfg.2
xyz.cfg.3
xyz.cfg.4
xyz.cfg.5
xyz.ndx
Each persistent index file is updated at the same time as the associated configuration file.
When the index file is updated, the save is performed to xyz.cfg and the index file is created
as xyz.ndx. Synchronization between the active and standby is performed for all
configurations and their associated persistent index files.
The no form of this command reverts the configuration to the default value.
Default 5