System Management
398
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Parameters count — Specifies the maximum number of backup revisions.
Values 1 to 9
contact
Syntax contact contact-name
no contact
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the contact name for the device.
Only one contact can be configured, if multiple contacts are configured the last one entered
will overwrite the previous entry.
The no form of this command reverts to the default.
Parameters contact-name — Specifies the contact name character string. The string may be up to 80
characters. Any printable, seven-bit ASCII characters can be used within the string.
If the string contains special characters (#, $, spaces, and so on), the entire string
must be enclosed within double quotes.
coordinates
Syntax coordinates coordinates
no coordinates
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command creates a text string that identifies the system coordinates for the device
location. For example, the command coordinates “37.390 -122.0550" is read as latitude
37.390 north and longitude 122.0550 west.
Only one set of coordinates can be configured. If multiple coordinates are configured, the last
one entered overwrites the previous entry.
The no form of this command reverts to the default value.
To Next Page
Loading...
