Nokia 7210 - Page 399

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
399
Parameters coordinates — Specifies the coordinates describing the device location character string.
The string may be up to 80 characters. Any printable, seven-bit ASCII characters can
be used within the string. If the string contains special characters (#, $, spaces, and
so on), the entire string must be enclosed within double quotes. If the coordinates are
subsequently used by an algorithm that locates the exact position of this node then
the string must match the requirements of the algorithm.
ip
Syntax ip
Context config>system
Platforms 7210 SAS-Mxp
Description Commands in this context configure system-wide IP router parameters.
allow-cpu-fragmentation
Syntax [no] allow-cpu-fragmentation
Context config>system>ip
Platforms 7210 SAS-Mxp
Description This command enables CPU-based IP fragmentation. When allow-cpu-fragmentation is
enabled, the CPM extracts oversized IPv4 packets from the datapath, fragments them using
the system CPU, and inserts the fragmented packets back into the datapath. Refer to the
7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for more information about
IP fragmentation.
The no form of this command disables CPU-based IP fragmentation.
Default no allow-cpu-fragmentation
lacp-system-priority
Syntax lacp-system-priority lacp-system-priority
no lacp-system-priority
Context config>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode