7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
451
end absolute-time — Specifies end parameters for the absolute time-range.
Values absolute-time — year/month/day,hh:mm
year — 2005 to 2099
month — 1 to 12
day — 1 to 31
hh — 0 to 23
mm — 0 to 59
daily
Syntax daily start start-time-of-day end end-time-of-day
no daily start
Context config>system>cron>time-range
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the start and end of a schedule for every day of the week. To
configure a daily time-range across midnight, use a combination of two entries. An entry that
starts at hour zero will take over from an entry that ends at hour 24.
The no form of this command removes the daily time parameters from the configuration.
Parameters start-time-of-day — Specifies the starting time for the time range.
Values start-time-of-day — hh:mm
hh — 0 to 23
mm — 0 to 59
end-time-of-day — Specifies the ending time for the time range.
Values end-time-of-day — hh:mm
hh — 0 to 23
mm — 0 to 59
weekdays
Syntax weekdays start start-time-of-day end end-time-of-day
no weekdays start
Context config>system>cron>time-range
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the start and end of a weekday schedule.
The no form of this command removes the weekday parameters from the configuration.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
