Nokia 7210 - Page 455

To Next Page

To Previous Page

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System

Configuration Guide

System Management

Use subject to Terms available at: www.nokia.com

455

time-range time-range-name — Specifies a name for the time-range, up to 32

characters. If the time-range is not populated the system will assume the assignment

to mean “all times”. Only one entry without a time-range is allowed for every type of

policy. The system does not allow the user to specify more than one policy with the

same time-range and priority.

priority priority — Specifies the priority of the time-range. Only one time-range

assignment of the same type and priority is allowed.

Values 1 to 10

mac mac-filter-id — Specifies a MAC filter for this tod-suite.

Values 1 to 65535

qos

Syntax qos policy-id [time-range time-range-name] [priority priority]

no qos policy-id [time-range time-range-name]

Context config>system>cron>tod-suite>ingress

Platforms Supported on all 7210 SAS platforms as described in this document, including platforms

configured in the access-uplink operating mode

Description This command creates time-range based associations of previously created QoS policies.

Multiple policies may be included and each must be assigned a different priority; in case time-

ranges overlap, the priority will be used to determine the prevailing policy. Only a single

reference to a policy may be included without a time-range.

The no form of this command reverts to the default.

Parameters policy-id — Specifies an egress QoS policy for this tod-suite.