7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
491
The no form of this command removes the parameter from the configuration.
Default config
Parameters boot-env — Keyword to synchronize all files required for the boot process (loader, BOF,
images, and config).
config — Keyword to synchronize only the primary, secondary, and tertiary
configuration files.
multi-chassis
Syntax multi-chassis
Context config>redundancy
Platforms Supported on all 7210 SAS platforms as described in this document
Description Commands in this context configure multi-chassis parameters.
peer-name
Syntax peer-name name
no peer-name
Context config>redundancy>multi-chassis>peer
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command specifies a peer name.
Parameters name — Specifies the peer name, up to 32 characters. Any printable, seven-bit ASCII
characters can be used within the string. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes.
source-address
Syntax source-address ip-address
no source-address
Context config>redundancy>multi-chassis>peer
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command specifies the source address used to communicate with the multi-chassis
peer.
To Next Page
Loading...
