Nokia 7210 - Page 492

System Management
492
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Parameters ip-address — Specifies the source address used to communicate with the multi-chassis
peer.
Values a.b.c.d (no multicast address)
sync
Syntax [no] sync
Context config>redundancy>multi-chassis>peer
Platforms Supported on all 7210 SAS platforms as described in this document
Description Commands in this context configure synchronization parameters.
igmp
Syntax [no] igmp
Context config>redundancy>multi-chassis>peer>sync
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command specifies whether IGMP protocol information should be synchronized with the
multi-chassis peer.
Default no igmp
igmp-snooping
Syntax [no] igmp-snooping
Context config>redundancy>multi-chassis>peer>sync
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command specifies whether IGMP snooping information should be synchronized with
the multi-chassis peer.
Default no igmp-snooping
port
Syntax port port-id [sync-tag sync-tag] [create]
no port port-id