Nokia 7210 - Page 493

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
493
Context config>redundancy>multi-chassis>peer>sync
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command specifies the port to be synchronized with the multi-chassis peer and a
synchronization tag to be used while synchronizing this port with the multi-chassis peer.
Parameters port-id — Specifies the port to be synchronized with the multi-chassis peer.
Values slot/mda/port or lag-id or pw-id
sync-tag — Specifies a synchronization tag, up to 32 characters, to be used while
synchronizing this port with the multi-chassis peer.
create — Keyword to create an entry.
range
Syntax range encap-range sync-tag sync-tag
no range encap-range
Context config>redundancy>multi-chassis>peer>sync>port
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command configures a range of encapsulation values.
Parameters encap-range — Specifies a range of encapsulation values on a port to be synchronized
with a multi-chassis peer.
Values dot1q — start-qtag-end-qtag
start-qtag — 0 to 4094
end-qtag — 0 to 4094
qinq — qtag1.start-qtag2-qtag1.end-qtag2-start-qtag1.*end-qtag1.*
qtag1 —1 to 4090
start-qtag1 — 1 to 4090
start-qtag2 — 1 to 4090
end-qtag1 — 1 to 4090
sync-tag sync-tag — Specifies a synchronization tag, up to 32 characters, to be used
while synchronizing this encapsulation value range with the multi-chassis peer.