Nokia 7210 - Page 495

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
495
6.12.2.1.13 Rollback Commands
compare
Syntax compare [to checkpoint2]
compare checkpoint1 to checkpoint2
Context admin>rollback
Platforms 7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Mxp
Description This command displays the differences between rollback checkpoints and the active
operational configuration, with checkpoint1 as the base/first file to which checkpoint2 is
compared.
When no parameters are defined, this command compares the active configuration to the
most recent rollback file. when the checkpoint2 parameter is defined, this command
compares the active configuration to the specified file. When both checkpoint parameters are
defined, this command compares one specified file to another specified file.
A compare operation does not check authorization of each line of output. Permission to
execute the compare command should only be given to users who are allowed to view the
entire system configuration.
The defaults for checkpoint1 and checkpoint2 are context-aware and differ based on the
branch in which the command is executed. In general, the default for checkpoint1 matches
the context from which the command is issued.
Parameters checkpoint1, checkpoint2 — Specifies the configuration files to use as comparison
sources.
Values active-cfg — The active operational system configuration.
rescue — The rollback rescue file from the configured rescue
location.
latest-rb — The most recent rollback checkpoint file from the
configured rollback location, with the suffix *.rb.
checkpoint-id — The ID value of a specific rollback checkpoint file
from the configured rollback location with the suffix *.rb.x. The range
is 1 to 9 but the maximum value depends on the local and remote
checkpoints. See local-max-checkpoints and remote-max-
checkpoints for more information.
delete
Syntax delete checkpoint | rescue
Context admin>rollback