Nokia 7210 - Page 500

System Management
500
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
remote-location — [hostname | ipv4-address | ipv6-address]
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
interface — 32 characters maximum, for link
local addresses
cflash-id — cf1:, cf2
usb-flash-id — uf1:
6.12.2.1.14 Peer Commands
peer
Syntax peer ip-address [create]
no peer ip-address
Context config>redundancy>multi-chassis
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command configures a multi-chassis redundancy peer.
Parameters ip-address — Specifies a peer IP address. Multicast address are not allowed.
Values a.b.c.d
create — Keyword to create the configuration context.
authentication-key
Syntax authentication-key authentication-key | hash-key [hash | hash2]
no authentication-key
Context config>redundancy>multi-chassis>peer
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command configures the authentication key used between this node and the multi-
chassis peer. The authentication key can be any combination of letters or numbers.