System Management
504
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context configure system-wide Link Layer Discovery Protocol parameters.
lldp-med
Syntax lldp-med
Context config>system>lldp
Platforms 7210 SAS-Sx/S 1/10GE: standalone and standalone-VC
Description This command creates the context to configure system-wide LLDP Media Endpoint
Discovery (LLDP-MED) information.
network-policy
Syntax network-policy network-policy-id [create]
no network-policy network-policy-id
Context config>system>lldp>lldp-med
Platforms 7210 SAS-Sx/S 1/10GE: standalone and standalone-VC
Description This command configures network policies, which send configuration information using
LLDP-MED TLVs. The configured policy specifies the network policy configuration that must
be provided to the LLDP-MED endpoint device. Multiple policies can be configured with
different application types.
By default, the system creates network policy 1, which is not associated with a port. The user
must explicitly configure a policy for use with a port, or use the default network policy 1, and
enable transmission and reception of LLDP-MED TLVs on the port.
The no form of the command removes the configured network policy ID.
Parameters network-policy-id — Specifies the network policy ID.
Values 1 to 65535
create — Keyword to create a network policy.
application-type
Syntax application-type {voice | voice-signaling | guest-voice | guest-voice-signaling | soft-
phone-voice | video-conferencing | streaming-video | video-signaling}
no application-type
To Next Page
Loading...
