Nokia 7210 - Page 507

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
507
Description This command configures the application specified by the application-type to use a VLAN
tagged packet, using the configured VLAN ID in the VLAN tag.
The no form of this command disables the use of a VLAN tag.
Default no vlan-tag-present
message-fast-tx
Syntax message-fast-tx time
no message-fast-tx
Context config>system>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the duration of the fast transmission period.
Parameters time — Specifies the fast transmission period, in seconds.
Values 1 to 3600
Default 1
message-fast-tx-init
Syntax message-fast-tx-init count
no message-fast-tx-init
Context config>system>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the number of LLDPDUs to send during the fast transmission
period.
Parameters count — Specifies the number of LLDPDUs to send during the fast transmission period.
Values 1 to 8
Default 4
notification-interval
Syntax notification-interval time
no notification-interval