Nokia 7210 - Page 508

System Management
508
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Context config>system>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the minimum time between change notifications.
Parameters time — Specifies the minimum time, in seconds, between change notifications.
Values 5 to 3600
Default 5
reinit-delay
Syntax reinit-delay time
no reinit-delay
Context config>system>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the time before reinitializing LLDP on a port.
Parameters time — Specifies the time, in seconds, before reinitializing LLDP on a port.
Values 1 to 10
Default 2
tx-credit-max
Syntax tx-credit-max count
no tx-credit-max
Context config>system>lldp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the maximum consecutive LLDPDUs transmitted.
Parameters count — Specifies the maximum consecutive LLDPDUs transmitted.
Values 1 to 100
Default 5