System Management
522
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
The no form of this command specifies that the software does not allocate any resources for
use by egress filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources
are allocated for use, the software fails all attempts to associate a service entity (for example,
SAP and IP interface) with a filter policy using this match criteria.
Default no ipv6-128bit-match-enable
Parameters num-resources — Specifies the maximum amount of resources for use by this filter
match criteria. A minimum value of 2 (indicating two chunks of resources) must be
allocated to use this match-criteria. If not, association of a policy with ipv6-128bit
criteria to a SAP will fail. It is mutually exclusive to use of SAP egress aggregate
meter.
Values Table 45 lists the parameter values.
mac-ipv4-match-enable
Syntax [no] mac-ipv4-match-enable num-resources
Context configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Table 45 Number of Resources Available for IPv6-128Bit-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 2 0
7210 SAS-T access-uplink mode (per node) 0 2 0
7210 SAS-T network mode (per node) 0 2 0
7210 SAS-Sx 1/10GE (standalone) 0 2 0
7210 SAS-Sx 1/10GE (standalone-VC) 0 2 0
7210 SAS-S 1/10GE (standalone) 0 2 0
7210 SAS-S 1/10GE (standalone-VC) 0 2 0
7210 SAS-Sx 10/100GE 0 2 0
7210 SAS-Mxp 0 2 0
7210 SAS-R6 and 7210 SAS-R12 0 2 0
7210 SAS-R6 (per IMM) 0 0 2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
