Nokia 7210 - Page 527

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
527
bidir-mip-egress
Syntax bidir-mip-egress [num-resources]
no bidir-mip-egress
Context configure>system>resource-profile>egress-internal-tcam>eth-cfm
Platforms 7210 SAS-R6 (IMMv2 and IMM-c) and 7210 SAS-R12 (IMMv2 and IMM-c)
Description This command allocates resources for the VPLS bi-directional MIP (both ingress and egress
directions) on SAPs only from the egress internal TCAM resource pool.
The no form of this command allocates no resources to this feature.
Default no bidir-mip-egress
Parameters num-resources — Specifies the number of resources to allocate.
Values 0 to 1
mac-auth-res
Syntax mac-auth-res num-resources
no mac-auth-res
Context config>system>resource-profile>egress-internal-tcam
config>system>resource-profile>ingress-internal-tcam
Platforms 7210 SAS-Mxp (standalone), 7210 SAS-R6 (all IMMs), 7210 SAS-Sx/S 1/10GE
(standalone), 7210 SAS-T (network and access-uplink operating modes)
Note:
• The resources in the egress internal TCAM resource pool are shared with other
features.
To assign resources to a specific feature, resources can be reallocated from other
features. For example, you can release resources by disabling the policies associated
with a SAP.
• Resources must be allocated from this pool before bi-directional MIPs can be
configured on VPLS SAPs.
• Bi-directional MIPs on VPLS SAPs can be enabled only when the bidir-mip-egress
resource slice is allocated and vpls-sap-bidir is enabled in the
configure>service>vpls>eth-cfm context.