Nokia 7210 - Page 528

System Management
528
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Description This command configures the allocation of resources for MAC authentication from the ingress
internal TCAM pool and egress internal TCAM pool. Resources must be allocated from both
ingress and egress TCAM pools before MAC authentication can be used. If resources are not
allocated from both pools, the system returns an error message and MAC authentication
cannot be enabled.
The configured number of resources specifies the number of resource pool slices allocated
for use by MAC authentication. One entry is used for each authenticated source MAC
address. The maximum number of MAC addresses that can be authenticated is limited by the
number of entries allocated to the feature using this command. The maximum number of
MAC address entries is limited by the maximum number of entries available in the ingress
internal TCAM pool and the egress internal TCAM pool.
The no form of this command removes all resources allocated to MAC authentication; further
attempts to enable MAC authentication on an Ethernet port using the mac-auth command
will fail unless resources are first reallocated using the mac-auth-res command. The no form
of the mac-auth-res command cannot be executed when MAC authentication is enabled on
at least one port.
Default no mac-auth-res
Parameters num-resources — Specifies the number of resources to allocate for MAC authentication.
Configuring a value of 0 is equivalent to configuring no mac-auth-res and effectively
disables MAC authentication.
Values 0 to 1
g8032-control-sap-tags
Syntax [no] g8032-control-sap-tags vlan-range
Context configure>system>resource-profile
Platforms 7210 SAS-Sx/S 1/10GE: standalone and standalone-VC, 7210 SAS-R6, 7210 SAS-R12
Description This command configures the range of VLANs per IMM to be used internally with G8032
MEPs that support hardware CCM message processing.
Use one of the VLANs configured with this command to configure the VLAN for the G8032
MEP configure>eth-ring>path>eth-cfm>mep>control-sap-tag.
Default no g8032-control-sap-tags
Note: Users must ensure that the VLANs configured for use with G8032 MEPs are not
configured for any of the SAPs configured on the IMM.