Nokia 7210 - Page 529

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
529
Parameters vlan-range — Specifies the range of VLANs per IM.
Values start-vlan — 3000 to 3512 (7210 SAS-R6 and 7210 SAS-R12)
512 to 768 (7210 SAS-Sx 1/10GE:standalone and
standalone-VC)
end -vlan — 3000 to 3512 (7210 SAS-R6 and 7210 SAS-R12)
512 to 768 (7210 SAS-Sx 1/10GE:standalone and
standalone-VC)
qos-sap-egress-resource
Syntax qos-sap-egress-resource num-resources
no qos-sap-egress-resource
Context config>system>res-prof>ingress-internal-tcam
Platforms 7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Mxp
Description This command configures resource allocation for SAP-based egress queuing from the
ingress-internal-tcam resource pool. If port-based queuing is disabled, users must allocate
resources for SAP-based egress queuing using this command. If no resources are allocated,
SAPs cannot be created.
When port-based queuing is enabled, resources can be taken away from SAP-based egress
queues and allocated to other features that share the ingress-internal-tcam pool (for example,
SAP ingress QoS and Ingress ACLs).
The no form of this command reverts to the default value.
Default 0
Parameters num-resources — Specifies the amount of resources that are allocated towards SAP-
based egress queues.
Values 0 to 2
eth-cfm
Syntax eth-cfm
Context configure>system>resource-profile
Platforms 7210 SAS-M
Note: This command is not supported on IMM-c cards. SAP functionality with per SAP
egress queues is not supported on IMM-c cards.