System Management
550
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
• On the 7210 SAS-R6 and 7210 SAS-R12, this is a per-IMM resource. For SAPs, the
resources are required only on the IMM for which the SAP is allocated. For SDP
bindings, resources are required on all IMMs because MPLS packets could be received
on any network port.
• Some entries are reserved for system internal use.
The no form of this command is not supported. At least a single slice must be allocated for
use with Down MEPs because some of the resources are reserved for system internal use.
The software enforces it and errors out an attempt to change it to a value less than 1.
Parameters num-resources — Specifies the maximum amount of resources for use by down-mep.
Values 1 to 3
Default 1
sap-down-mep
Syntax sap-down-mep num-resources
no sap-down-mep
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms 7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command configures resources for CFM/Y.1731 down MEPs on SAPs.
The no form of this command removes resources for down MEPs on SAPs.
Default 1
Parameters num-resources — Specifies the maximum amount of resources for use by down MEPs
on SAPs.
Values 1
sdp-down-mep-ing-mip
Syntax sdp-down-mep-ing-mip num-resources
no sdp-down-mep-ing-mip
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms 7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command configures resources for CFM/Y.1731 Down MEPs on SDPs and ingress
MIPs on SAPs and SDP bindings. In addition, resources for bidirectional MIPs configured on
an Epipe SAP and Epipe SDP binding are allocated from this pool.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
