Nokia 7210 - Page 549

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
549
down-mep
Syntax down-mep num-resources
no down-mep
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE, and
7210 SAS-Sx 10/100GE
Description This command enables the user to allocate more resources and increase the number of CFM/
Y.1731 Down MEPs. By default, the system allocates a single slice for use with Down MEP.
Resources from this pool are allocated towards the following:
• down MEP on SDP binding
• on the 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone), and 7210 SAS-Sx 10/
100GE (standalone), ingress and egress MIPs for Epipe SAPs and Epipe SDP bindings
• on the 7210 SAS-R6 and 7210 SAS-R12, ingress and egress MIPs (that is, bidirectional
MIPs) for Epipe SAPs and Epipe SDP bindings
7210 SAS-R6 and 7210 SAS-R12 (per IMM-
c)
131
7210 SAS-Mxp (per node) 1 3 1
7210 SAS-Sx 1/10GE (per node)
(standalone)
131
7210 SAS-Sx 1/10GE (standalone-VC) 2 4 2
7210 SAS-S 1/10GE (per node)
(standalone)
131
7210 SAS-S 1/10GE (standalone-VC) 2 4 2
7210 SAS-Sx 10/100GE (per node) 1 3 1
Table 58 Number of Resources Available for ETH-CFM (Continued)
Platforms Min value
(per node)
Max value
(per node)
Default
Note: On the 7210 SAS-R6 and 7210 SAS-R12, bidirectional MIPs also use the Up MEP
resource pool.