System Management
662
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
script-control
Syntax script-control
Context show>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context display script information.
script
Syntax script [script-name] [owner script-owner]
Framing The framing configured for the BITS port
Line Coding The line coding configured for the BITS port
Line Length The line length value of the BITS output
Output Admin Status down — The BITS output is administratively shutdown
up — The BITS output is administratively enabled
diag — Indicates the BITS output has been forced using the
force-reference command
Output Reference
Selected
The reference selected as the source for the BITS output signal
(ref1 or ref2)
TX Quality Level QL value for BITS output signal
Quality Level Selection Indicates whether the ql-selection command has been enabled
or disabled
If this command is enabled, the reference is selected first using
the QL value, then by the priority reference order. If this
command is not enabled, the reference is selected by the priority
reference order.
System Quality Level Indicates the quality level being generated by the system clock
Rx Quality Level Indicates the QL value received on the interface
inv — SSM received on the interface indicates an invalid code for
the interface type
unknown — No QL value was received on the interface
Table 90 Output Fields: Sync Interface Timing (Continued)
Label Description (Continued)
To Next Page
Loading...
