EasyManuals Logo

Nokia MOBILE TERMINAL User Manual

Nokia MOBILE TERMINAL
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
General RF troubleshooting
Introduction to RF troubleshooting
Most RF semiconductors are static discharge sensitive
ESD protection must be applied during repair (ground straps and ESD soldering irons).
Pre-baking
These parts are moisture sensitive and must be pre-baked prior to soldering:
RFIC N7505
Front End Module (FEM) N7520
WCDMA PA N7540
Discrete components
In addition to the key-components, there are a number of discrete components (resistors, inductors and
capacitors) for which troubleshooting is done mainly by
visual inspection
.
Capacitors: check for short circuits.
Resistors: check value with an ohm meter.
Note: In-circuit measurements should be evaluated carefully
Measuring equipment
All measurements should be done using:
An oscilloscope for low frequency and DC measurements. Recommended probe: 10:1, 10Mohm//8pF.
A radio communication tester including RF generator and spectrum analyser, for example Rohde & Schwarz
CMU200. (Alternatively a spectrum analyser and an RF generator can be used. Some tests in this guide are
not possible to perform if this solution is chosen).
Note: A mobile phone WCDMA transmitter should never be tested with full TX power (only it possible
to perform the measurements in a good RF-shielded room). Even low power WCDMA transmitters
may disturb nearby WCDMA networks and cause problems to 3G cellular phone communication in
a wide area.
Note: All measurements with an RF coupler should be performed in an RF-shielded environment
because nearby base stations can disturb sensitive receiver measurements. If there is no possibility
to use RF shielded environment, testing at frequencies of nearby base stations should be avoided.
Level of repair
The scope of this guideline is to enable repairs at key-component level. Some key-components are not
accessible without replacing the whole shield frame (i.e. not replaceable). Please refer to the list of Non-
replaceable RF components (page 4–8).
RM-356
RF troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 –5
Copyright © 2008 Nokia. All rights reserved.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia MOBILE TERMINAL and is the answer not in the manual?

Nokia MOBILE TERMINAL Specifications

General IconGeneral
BrandNokia
ModelMOBILE TERMINAL
CategoryCell Phone
LanguageEnglish

Related product manuals