WCDMA RX chain activation for manual measurement
Prerequisites
Make the following settings in Phoenix service software:
Setting WCDMA2100 WCDMA900
Phoenix Channel 10700 3012
Signal generator to antenna
connector
2141.0 MHz 942,4 MHz
Band I VIII
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings:
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
4. Set the following RF generator settings:
RM-356
RF troubleshooting
Page 4 –20 COMPANY CONFIDENTIAL Issue 1
Copyright © 2008 Nokia. All rights reserved.
To Next Page
Loading...
