22
SAVE and Man Overboard (MOB)
Northstar 6000i
When the three-digit number reaches the
specified maximum, it wraps back to 001
and overwrites the older waypoint that has
the same number.
Any saved waypoints that you want to
keep or use in a route should be renamed
before they are overwritten (see Editing
waypoints, starting on page 70).
Saving routes
You can set the 6000i to automatically
save a sequence of waypoints as a route.
Each time you press SAVE, your position
will be recorded as an additional waypoint
in the route. See Saving a route as you
travel, starting on page 74 for details.
Man Overboard
Press and hold the SAVE/MOB for at least
four seconds (until you see the “Man Over-
board” window) to save your position as a
waypoint named –MOB– and immediately
start navigating to it. The 6000i switches to
a zoomed-in chart screen showing your
vessel and the MOB waypoint. You can use
any of the unit’s functions to return to the
location of the waypoint.
Press any key to go back to normal
operation.
To Next Page
